usb 1-1: Keyspan PDA converter now attached to as all of us can see the device is now properly assigned. keyspan_pda 1-1:1.0: Keyspan PDA converter detected
#Tripp lite keyspan driver windows 7 serial
usb 1-1: Product: ACME USB serial widget usb 1-1: New USB device strings: Mfr=1, Product=2, SerialNumber=3 usb 1-1: New USB device found, idVendor=06cd, idProduct=0104 usb 1-1: new full-speed USB device number 5 using dwc_otg Indeed it is in host mode hprt0 = 00021501 keyspan_pda 1-1:1.0: device disconnected usb 1-1: USB disconnect, device number 4 keyspan_pda 1-1:1.0: Keyspan PDA - (prerenumeration) converter detected keyspan: probe of 1-1:1.0 failed with error -2 usb 1-1: failed to load firmware "keyspan/usa19.fw"
usb 1-1: ezusb_ihex_firmware_download - request "keyspan/usa19.fw" failed usb 1-1: Direct firmware load for keyspan/usa19.fw failed with error -2 keyspan 1-1:1.0: Keyspan - (without firmware) converter detected usb 1-1: New USB device strings: Mfr=0, Product=0, SerialNumber=0 usb 1-1: New USB device found, idVendor=06cd, idProduct=0103 I confess I just went through the same problem, now about two years later, and found that after installing the firmware describe there, I needed to unplug it and to then plug it back in, this is a regular USA-19 dmesg | tail -20 usb 1-1.4: Keyspan 1 port adapter converter now attached to ttyUSB0 keyspan 1-1.4:1.0: Keyspan 1 port adapter converter detected usbserial: USB Serial support registered for Keyspan 4 port adapter usbserial: USB Serial support registered for Keyspan 2 port adapter usbserial: USB Serial support registered for Keyspan 1 port adapter usbserial: USB Serial support registered for Keyspan - (without firmware) usbcore: registered new interface driver keyspan usbserial: USB Serial support registered for generic usbcore: registered new interface driver usbserial_generic usbcore: registered new interface driver usbserial usb 1-1.4: Manufacturer: Keyspan, a division of InnoSys Inc. usb 1-1.4: New USB device strings: Mfr=1, Product=2, SerialNumber=0 usb 1-1.4: New USB device found, idVendor=06cd, idProduct=0121 usb 1-1.4: new full-speed USB device number 7 using dwc_otg Bluetooth: BNEP socket layer initialized
Bluetooth: BNEP filters: protocol multicast Bluetooth: BNEP (Ethernet Emulation) ver 1.3 Bluetooth: HCI UART protocol BCM registered Bluetooth: HCI UART protocol Three-wire (H5) registered Actually it is being recognized, but is not responding to key strokes.